1 3
Bently Nevada

Bently Nevada 330104-00-08-90-02-05 Proximity Probe
SKU: 330104-00-08-90-02-05
In stock: 15
Description

Bently Nevada 330104-00-08-90-02-05 Proximity Probe

Configured for machinery protection and condition monitoring in turbomachinery systems, the Bently Nevada 330104-00-08-90-02-05 (330104 proximity probe) provides direct non-contact eddy current transducer execution.

Part Number Breakdown

  • Model (330104): 3300 XL 8 mm proximity probe
  • Unthreaded Length (00): 0 mm unthreaded portion
  • Overall Case Length (08): 80 mm (8 cm) case length
  • Total Length (90): 9.0-meter (29.5-feet) total cable length
  • Connector/Cable (02): Miniature coaxial ClickLoc connector with standard cable
  • Agency Approval (05): CSA, ATEX, and IECEx hazardous area approvals

Hardware Specifications

Parameter Specification
Model 330104-00-08-90-02-05
Brand Bently Nevada
Origin USA
Weight Not specified
Dimensions Tip diameter 8 mm; case length 80 mm; total cable length 9.0 m
Operating Temp Not specified
Power Consumption Passive probe, excitation via proximitor
Core Performance Non-contact eddy current transducer; Viton O-ring sealing; miniature coaxial ClickLoc connector

Eddy-Current Probe Scaling and Gap Voltage Validation

The probe operates with calibrated eddy-current scaling to ensure accurate rotor dynamic measurements. Gap voltage validation targets -10 VDC reference points, enabling precise monitoring of shaft displacement. Signal cross-talk suppression is integrated through coaxial shielding, minimizing interference across multiple probe channels.

Frequently Asked Questions

Q: Does the 330104 probe support hot-swap installation? A: No. The probe requires full system shutdown before removal or replacement to maintain calibration integrity.

Q: What is the typical backplane current load when connected to a proximitor? A: The probe itself is passive; current load is determined by the proximitor driver, not the probe.

Q: Is firmware compatibility relevant for this probe? A: No. The probe is a passive transducer and does not contain firmware. Compatibility is defined by proximitor module configuration.

Field Installation Guidelines

  • Ensure probe tip is inserted with full thread engagement to maintain mechanical stability.
  • Ground coaxial shielding at the proximitor end to suppress cross-talk and noise.
  • Route cables away from high-voltage lines to avoid induced interference.
  • Maintain sealing integrity by verifying Viton O-ring compression between probe tip and case.
  • Confirm hazardous area approvals (CSA, ATEX, IECEx) before installation in classified zones.